Figure 34. Removing the optional I/O module (HDMI, DP, or PS2)
Figure 35. Removing the optional I/O module (VGA or Serial)
Steps
1. Remove the two (M3x3) screws that secure the optional I/O module (HDMI/DP/PS2) or two (M2x5) cross-type screws
that secure the optional I/O module (VGA/Serial) to the computer chassis.
2. Disconnect the I/O-module cable from the connector (VIDEO) or (KB MS SERIAL) on the system board, whichever is
applicable.
3. Remove the optional I/O module from the computer.
Removing and installing Field Replaceable Units (FRUs)
59
To Next Page
Loading...
