Steps
1. To remove the knock-out port cover, insert a flat-head screwdriver in the hole of the port cover from the outside of the
computer. Push the knock-out port cover to release it, and then remove it out from the computer.
NOTE: This step applies if you are upgrading a computer with no existing I/O module.
2. Insert the optional I/O module into its slot at the back panel of the computer.
3. Connect the I/O cable to the connector (VIDEO) or (KB MS SERIAL) on the system board, whichever is applicable.
4. Replace the two (M3x3) screws that secure the optional I/O module (HDMI/DP/PS2) or two (M2x5) cross-type screws
that secure the optional I/O module (VGA/Serial) to the computer chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Optional Type-C module
Removing the optional Type-C module
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional Type-C module and provide a visual representation of the removal
procedure.
Figure 38. Removing the optional Type-C module
Removing and installing Field Replaceable Units (FRUs)
61
To Next Page
Loading...
