Figure 24. Installing the M.2 2280 solid-state drive in slot 0
Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the solid-state drive slot 0 (M.2 PCIe SSD 0).
2. Slide the M.2 2280 solid-state drive into the solid-state drive slot (M.2 PCIe SSD 0) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the speaker.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid-state drive from slot 1
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive
installed in solid-state drive slot 1 (M.2 PCIe SSD 1).
NOTE: This procedure is applicable for computers where an M.2 2280 solid-state drive is installed in solid-state drive slot 1
(M.2 PCIe SSD 1).
The following image(s) indicate the location of the M.2 2280 solid-state drive in slot 1 and provides a visual representation of
the removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
47
To Next Page
Loading...
