Figure 18. Installing the speaker
Steps
1. Press and hold on the tab that secures the speaker to the speaker-support bracket.
2. Place the speaker on the bracket.
3. Release the tab that secures the speaker to the speaker-support bracket.
4. Route the speaker cable through the routing guides on the fan assembly.
5. Connect the speaker cable to its connector (INT SPKR) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Solid state drive
Removing the M.2 2230 solid-state drive from slot 0
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the speaker.
About this task
NOTE:
Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive
that is installed in solid-state drive slot 0 (M.2 PCIe SSD 0).
NOTE: This procedure is applicable for computers where an M.2 2230 solid-state drive is installed in solid-state drive slot 0
(M.2 PCIe SSD 0).
Removing and installing Customer Replaceable Units (CRUs) 41
To Next Page
Loading...
