Steps
1. Remove the two (M2x3) screws that secure the optional Type-C module.
2. Slide the optional Type-C module away from its slot on the chassis.
3. Flip over the optional Type-C module and hold it in place over the system board.
4. Disconnect the Type-C DisplayPort cable from its connector (VIDEO) on the system board.
5. Disconnect the Type-C USB cable from its connector (TYPE-C) on the system board.
6. Remove the optional Type-C module from the computer.
Installing the optional Type-C module
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional Type-C module and provide a visual representation of the installation
procedure.
Figure 39. Installing the optional Type-C module
Steps
1. To remove the knock-out port cover, insert a flat-head screwdriver in the hole of the bracket from the outside of the
computer. Push the bracket to release it, and then remove it out from the computer.
NOTE: This step applies if you are upgrading the computer with no existing I/O module.
2. Connect the Type-C DisplayPort cable to its connector (VIDEO) on the system board.
3. Connect the Type-C USB cable to its connector (TYPE-C) on the system board.
4. Insert the optional Type-C module into its slot on the back panel of the computer.
5. Replace the two (M3x3) screws that secure the optional Type-C module.
62
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
