CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE: Repeat step 1 to step 2 to remove any other memory modules installed in your computer.
NOTE: Note the slot and the orientation of the memory module in order to replace it in the correct slot.
Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The DDR5 thermal pad is required for the following memory configurations:
1. 32 GB: 2 x 16 GB, DDR5, 5600 MT/s, SoDIMM, dual-channel
2. 64 GB: 2 x 32 GB, DDR5, 5600 MT/s, SoDIMM, dual-channel
The following image(s) indicate the location of the memory and provides a visual representation of the installation procedure.
Figure 33. Installing the memory module
56
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
