2. Remove the side cover.
3. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
4. Remove the wireless card.
5. Remove the speaker.
6. Remove the fan.
7. Remove the heat sink.
8. Remove the optional I/O module (HDMI/VGA/DP/Serial/PS2) or the optional Type-C module, whichever is applicable.
9. Remove the system board.
NOTE: The system board can be removed with the memory, coin-cell battery, and processor attached.
.
About this task
The following image(s) indicate the location of the antenna module (black cable) and provides a visual representation of the
removal procedure.
Figure 52. Removing the antenna module (black cable)
Steps
1. Remove the antenna cable from the routing guides on the chassis.
2. Loosen the captive screw that secures the antenna module (while cable) to the chassis.
3. Lift the antenna module (black cable) from the chassis.
Installing the antenna module (black cable)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the antenna module (black cable) and provides a visual representation of the
installation procedure.
76
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
