Installing the optional I/O module (HDMI/VGA/DP/Serial/PS2)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: The optional PS2 module comes with a custom Dell adapter cable that is required to access the PS2 I/O port. Plug
in the adapter cable to access the PS2 I/O or COM port of your computer.
The following images indicate the location of the optional I/O module and provide a visual representation of the installation
procedure.
Figure 36. Installing optional I/O module (HDMI, DP, or PS2)
Figure 37. Installing optional I/O module (VGA or Serial)
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
