Figure 55. Installing SMA antenna (Location 3)
Steps
1. Remove the fillers on the side cover, if applicable.
2. Tilt the SMA antenna assembly.
3. Align and place the antenna bracket on the system board.
4. Insert the SMA antenna assembly through the opening at the back of the chassis.
5. Align the screw hole on the SMA antenna assembly with the screw hole.
6. Replace the screw (M3x3) that secures the SMA antenna assembly to the chassis.
7. Route the SMA antenna assembly cables through the routing guides on the chassis.
Next steps
1. Install the wireless card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
