About your monitor │ 31
Driver installation
Install the Realtek USB GBE Ethernet Controller Driver available for your system.
This is available for download at www.dell.com/support under the Driver and
download section.
Network (RJ45) data rate via USB-C max speed is 1000 Mbps.
NOTE: This LAN port is 1000Base-T IEEE 802.3az compliant,
supporting Mac Address (Printed on model label) Pass-thru (MAPT),
Wake-on-LAN (WOL) from standby mode (S3/S4/S5 only) and UEFI*
PXE Boot function [UEFI PXE Boot is not supported on Dell Desktop
PC’s (except for OptiPlex 7090/3090 Ultra Desktop)], these 3
features depend on BIOS settings and version of the OS. Functionality
may vary with Non Dell PC’s.
*UEFI stands for Unified Extensible Firmware Interface.
RJ45 connector LED status
21
Label LED Color Description
1 Left LED Green
Link/Activity indicator:
• Blinking - Activity on the port.
• Green On - Link is being established.
• Off - Link is not established.
2 Right LED Amber or Green
Speed indicator:
• Amber On - 1000 Mbps
• Green On - 100 Mbps
• Off - 10 Mbps
NOTE: The RJ45 cable is non in-box standard accessory.
To Next Page
Loading...
