Dell PowerConnect 8132 - Page 1138

1138 Configuring Differentiated Services
console(config-policy-map)#class development_dept
console(config-policy-classmap)#assign-queue 4
console(config-policy-classmap)#exit
console(config-policy-map)#exit
4 Attach the defined policy to 10-Gigabit Ethernet interfaces 1/0/1 through
1/0/4 in the inbound direction
console(config)#interface tengigabitethernet 1/0/1
console(config-if-
Te1/0/1)#service-policy in internet_access
console(config-if-
Te1/0/1)#exit
console(config)#interface
tengigabitethernet 1/0/2
console(config-if-
Te1/0/2)#service-policy in internet_access
console(config-if-
Te1/0/2)#exit
console(config)#interface
tengigabitethernet 1/0/3
console(config-if-
Te1/0/3)#service-policy in internet_access
console(config-if-
Te1/0/3)#exit
console(config)#interface
tengigabitethernet 1/0/4
console(config-if-
Te1/0/4)#service-policy in internet_access
console(config-if-
Te1/0/4)#exit
5 Set the CoS queue configuration for the (presumed) egress 10-Gigabit
Ethernet interface 1/0/1 such that each of queues 1, 2, 3 and 4 get a
minimum guaranteed bandwidth of 25%. All queues for this interface use
weighted round robin scheduling by default. The DiffServ inbound policy
designates that these queues are to be used for the departmental traffic
through the assign-queue attribute. It is presumed that the switch will
forward this traffic to 10-Gigabit Ethernet interface 1/0/1 based on a
normal destination address lookup for internet traffic.
console(config)#interface tengigabitethernet 1/0/5
console(config-if- Te 1/0/5)#cos-queue min-bandwidth 0 25 25 25 25 0 0
console(config-if-Te1/0/5)#exit
console(config)#exit