Dell PowerConnect 8132 - Communities

Configuring SNMP 285
Communities
Access rights for SNMPv1 and SNMPv2 are managed by defining
communities Communities page. When the community names are changed,
access rights are also changed. SNMP Communities are defined only for
SNMP v1 and SNMP v2.
To display the Communities page, click System
→ SNMP → Communities
in the navigation panel.
Figure 13-9. SNMP Communities
Adding SNMP Communities
To add a community:
1
Open the Communities page.
2 Click Add .
The
Add SNMPv1,2 Community page displays: