EasyManua.ls Logo

Dell PowerConnect 8132 - Configuring LLDP

Dell PowerConnect 8132
1294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
676 Discovering Network Devices
4
Exit to Privileged EXEC mode and view the LLDP settings for the switch
and for interface 1/0/3.
console(config-if-Te1/0/3)# <CTRL + Z>
console#show isdp
Timer....................................45
Hold Time................................60
Version 2 Advertisements.................Enabled
Neighbors table time since last change...00 days
00:00:00
Device ID................................none
Device ID format capability........ Serial Number,
Host Name
Device ID format.................. Serial Number
console#show isdp interface te1/0/3
Interface Mode
--------------- ----------
Te1/0/3 Enabled
Configuring LLDP
This example shows how to configure LLDP settings for the switch and to
allow 10-Gigabit Ethernet port 1/0/3 to transmit all LLDP information
available.
To configure the switch:
1
Configure the transmission interval, hold multiplier, and reinitialization
delay for LLDP PDUs sent from the switch.
console#configure
console(config)#lldp timers interval 60 hold 5
reinit 3
2
Enable port 1/0/3 to transmit and receive LLDP PDUs.
console(config)#interface TengigabitEthernet1/0/3
console(config-if-Te1/0/3)#lldp transmit
console(config-if-Te1/0/3)#lldp receive

Table of Contents

Other manuals for Dell PowerConnect 8132

Related product manuals