EasyManuals Logo

Dell PowerConnect 8164F User Manual

Dell PowerConnect 8164F
1294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1007 background imageLoading...
Page #1007 background image
Configuring OSPF and OSPFv3 1007
Configuring OSPFv3 Route Redistribution Settings
Beginning in Privileged EXEC mode, use the following commands to
configure OSPFv3 route redistribution settings.
Command Purpose
configure Enter global configuration mode.
ipv6 router ospf Enter OSPFv3 configuration mode.
redistribute {static |
connected} [metric
metric
] [metric-type {1 |
2}] [tag
tag
]
Configure OSPFv3 to allow redistribution of routes from
the specified source protocol/routers.
•
static
— Specifies that the source is a static route.
•
connected
— Specifies that the source is a directly
connected route.
•
metric
— Specifies the metric to use when
redistributing the route. (Range: 0–16777214)
•
metric-type 1
— Type 1 external route.
•
metric-type 2
— Type 2 external route.
•
tag
— Value attached to each external route, which
might be used to communicate information between
ASBRs. (Range: 0–4294967295)
exit Exit to Global Config mode.
exit Exit to Privileged EXEC mode.
show ipv6 ospf View OSPFv3 configuration and status information,
including information about redistributed routes.

Table of Contents

Other manuals for Dell PowerConnect 8164F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 8164F and is the answer not in the manual?

Dell PowerConnect 8164F Specifications

General IconGeneral
Enclosure TypeRack-mountable - 1U
Power DeviceInternal power supply
Installed Qty1
Power RedundancyOptional
Power SupplyAC 120/230 V (50/60 Hz)
Width17.3 in
Height1.7 in
Device TypeSwitch
Forwarding Rate960 Mpps
MAC Address Table Size128000 entries
Routing ProtocolOSPF, RIP-1, RIP-2, BGP, VRRP, OSPFv3, RIPng
Remote Management ProtocolSNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP, SSH-2, CLI
ManagementWeb based management
FeaturesFlow control, VLAN support, DHCP support, BOOTP support, port mirroring, IPv6 support, DiffServ support, Weighted Round Robin (WRR) queuing, Access Control List (ACL) support, Quality of Service (QoS), Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, Jumbo Frames support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3x, IEEE 802.1w, IEEE 802.1x, IEEE 802.1s
Jumbo Frame Support9KB

Related product manuals