Dell PowerConnect 8164F - LACP Parameters

798 Configuring Link Aggregation
LACP Parameters
Dynamic link aggregation is initiated and maintained by the periodic
exchanges of LACP PDUs. Use the LACP Parameters page to configure
LACP LAGs.
To display the LACP Parameters page, click Switching
→ Link Aggregation
→ LACP Parameters in the navigation panel.
Figure 28-3. LACP Parameters
Configuring LACP Parameters for Multiple Ports
To configure LACP settings:
1
Open the LACP Parameters page.
2 Click Show All .
The
LACP Parameters Table page displays.