Related Links
Safety instructions
Before working inside your system
Installing the optional rSPI card
After working inside your system
Installing the optional rSPI card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the rSPI card.
CAUTION: To prevent damage to the rSPI card, hold the card only by its edges.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other
components inside the system.
Steps
1. Align the two screw holes on the rSPI card with the standoffs on the system board.
2. Install the two screws to secure the rSPI card to the system board.
Figure 33. Installing the rSPI card
1. screw (2) 2. rSPI card
3. standoff (2) 4. connector
101
To Next Page
Loading...
