3
Option Description
X2Apic Mode
Enables or disables the X2Apic mode.
Dell Controlled
Turbo
Numberof Cores
per Processor
Processor 64-bit
Support
Processor Core
Speed
Controls the turbo engagement. Enable this option onlywhen System Profile is set to Performance.
NOTE: Depending on the number of installed CPUs, there may be up to four processor listings.
Controls the number of enabled cores in each processor. This option is set to All by default.
Specifies if the processor(s) support 64-bit extensions.
Specifies the maximum core frequency of the processor.
Processor 1
NOTE: Depending on the number of CPUs, there may be up to four processors listed.
The following settings are displayed for each processor installed in the system:
Option Description
Family-Model-
Stepping
Specifies the family,model, and stepping of the processor as defined by Intel.
Brand
Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Related links
Processor Settings
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on your system.
Related links
SATA Settings details
System BIOS
Viewing SATA Settings
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1.
Turn on, or restart your system.
2.
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to
finish
booting, and then
restart your system and try again.
3.
On the System Setup Main Menu screen, click System BIOS.
4.
On the System BIOS screen, click SATASettings.
Related links
SATA Settings
SATA Settings details
To Next Page
Loading...
