Dell PowerEdge R860 - Page 104

Figure 64. Configuration 12: 24 x 2.5-inch (SAS4/SATA) + 2 x 2.5-inch (SAS/SATA) with fPERC 11
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 80. 24 x 2.5-inch (SAS4/SATA) + 2 x 2.5-inch (SAS/SATA) with fPERC 11
Order From To
1 CTRL_SRC_SB1 (fPERC controller
connector)
BP_DST_SB1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on
system board)
CTRL_DST_PA1 (fPERC controller connector)
3 BP_SRC_SA2 (backplane controller
connector)
BP_DST_SA1 and BP_DST_SB1 (Rear backplane
signal connector)
4 SIG_PWR_2 (system board power
connector)
BP_PWR_2 (backplane power connector)
5 SIG_PWR_1 (system board power
connector)
BP _PWR_1 (backplane power connector)
6 SIG_PWR_0/BATT2 (system board power
connector)
BP _PWR_1 (Rear backplane power connector)
7 CTRL_SRC_SA1 (fPERC controller
connector)
BP_DST_SA1 (backplane signal connector)
NOTE: An 8 x 2.5-inch NVMe backplanes with fPERC H755 should be assembled outside and inserted into the system,
along with all necessary cables.
104 Installing and removing system components