Dell PowerEdge R860 - Page 110

NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 86. 16 x 2.5-inch (SAS4/SATA) with fPERC 11
Order From To
1 CTRL_SRC_SB1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system
board)
CTRL_DST_PA1 (fPERC controller
connector)
3 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
4 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
Figure 71. Configuration 19: 16 x 2.5-inch (SAS4/SATA) with fPERC 12
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 87. 16 x 2.5-inch (SAS4/SATA) with fPERC 12
Order From To
1 CTRL_SRC_SB1_PB1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system
board)
CTRL_DST_PA1 (fPERC controller
connector)
3 SL5_CPU1_PB3 (signal connector on system
board)
CTRL_DST_PB1 (fPERC controller
connector)
4 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
5 SIG_PWR_1 (system board power connector) BP _PWR_1 (backplane power connector)
6 CTRL_SRC_SA1_PA1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
110 Installing and removing system components