Figure 69. Configuration 17: 8 x 2.5-inch SAS/SATA
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 85. 8 x 2.5-inch SAS/SATA
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL4_CPU1_PA4 (signal connector on system
board)
CTRL_DST_PA1 (fPERC controller
connector)
Figure 70. Configuration 18: 16 x 2.5-inch (SAS4/SATA) with fPERC 11
Installing and removing system components
109
To Next Page
Loading...
