Table 54. NVMe-oF SubSystem n Settings (continued)
Option Description
DHCP Enables and disables the DHCP for this NVMe-oF connection. This option is set to
Disabled by default.
Host IP Address Specifies the Host IP Address for this NVMe-oF connection.
Host Subnet Mask Specifies the Host Subnet Mask for this NVMe-oF connection.
Host Gateway Specifies the Host Gateway for this NVMe-oF connection.
NVMe-oF subsystem info via DHCP Enables and disables the NVMe-oF subsystem's DHCP for this connection. This
option is set to Disabled by default.
NVMe-oF subsystem NQN Specifies the NVMe-oF subsystem's NQN for this connection.
NVMe-oF subsystem Address Specifies the NVMe-oF subsystem's IP address for this connection.
NVMe-oF subsystem Port Specifies the NVMe-oF subsystem's port for this connection. This option is set to
4420 by default.
NVMe-oF subsystem NID Specifies the NamespaceID (NID) for this NVMe-oF connection.
NVMe-oF subsystem Controller ID Specifies the NVMe-oF subsystem's Controller ID for this connection. This option
is set to 0 by default.
Security Enables or disables the security option for this NVMe-oF connection. This option is
set to Disabled by default.
Authentication Type Specifies the authentication type for this NVMe-oF connection. This option is set
to None by default.
Securitykeypath Specifies the Securitykeypath for this NVMe-oF connection.
Integrated Devices
To view the Integrated Devices screen, power on the system, press F2, and click System Setup Main Menu > System BIOS
> Integrated Devices.
Table 55. Integrated Devices details
Option Description
User Accessible USB Ports Configures the user accessible USB ports. Selecting Only Back Ports On
disables the front USB ports; selecting All Ports Off disables all front and
back USB ports; selecting All Ports Off (Dynamic) disables all front and back
USB ports during POST and front ports can be enabled or disabled dynamically
by authorized user without resetting the system. This option is set to All Ports
On by default.
The USB keyboard and mouse still function in certain USB ports during the
boot process, depending on the selection. After the boot process is complete,
the USB ports will be enabled or disabled as per the setting.
Internal USB Port Enables or disables the internal USB port. This option is set to On or Off. This
option is set to On by default.
iDRAC Direct USB Port The iDRAC Direct USB port is managed by iDRAC exclusively with no host
visibility. This option is set to ON or OFF. When set to OFF, iDRAC does not
detect any USB devices installed in this managed port. This option is set to On
by default.
Integrated Network Card1 Enables or disables the integrated network card. When this option is set to
Disabled, the card is not available to the operating system.
NOTE: If set to Disabled (operating system), the Integrated NICs might
still be available for shared network access by iDRAC.
54 Pre-operating system management applications
To Next Page
Loading...
