Dell poweredge t330 - Re-Enabling the TPM for Bitlocker Users; Re-Enabling the TPM for TXT Users

Figure 58. Installing the TPM
1. TPM 2. TPM connector
3. slot on the TPM connector 4. plastic bolt
5. slot on the system board
Next steps
1. Install the system board.
2. Follow the procedure listed in After working inside your system.
Related Tasks
Installing the system board
Re-enabling the TPM for BitLocker users
Initialize the TPM.
For more information about initializing the TPM, see http://technet.microsoft.com/en-us/library/
cc753140.aspx.
The TPM Status changes to Enabled, Activated.
Re-enabling the TPM for TXT users
1. While booting your system, press F2 to enter System Setup.
2. In the System Setup Main Menu, click System BIOS → System Security Settings.
3. In the TPM Security option, select On with Pre-boot Measurements.
4. In the TPM Command option, select Activate.
5. Save the settings.
137