3. Turn the system feet inward.
4. Place the system on its side on a flat and stable surface.
Steps
Remove the screws securing the system feet to the base of the tower.
Figure 11. Removing and installing the system feet
1. screw hole (4) 2. slot (12)
3. tab (12) 4. base of the tower
5. system feet (4) 6. screw (4)
Related Tasks
Installing the system feet
Installing the system feet
Prerequisites
CAUTION: Installing the feet on a stand-alone tower system is necessary to provide a stable
foundation for the system. Failure to install the feet poses the risk of having the system tip over,
possibly causing bodily injury or damage to the system.
1. Ensure that you follow the Safety instructions.
2. Keep the Phillips #2 screwdriver ready.
3. Place the system on its side on a flat and stable surface.
53
To Next Page
Loading...
