Figure 31. Installing the memory module
1. memory module 2. alignment key
3. memory module socket ejector (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in After working inside your system.
3. Press F2 to enter System Setup, and check the System Memory setting.
The System Memory Size should reflect the installed memory.
4. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure
that the memory modules are firmly seated in the sockets.
5. Run the system memory test in system diagnostics. See Dell Embedded System Diagnostics.
Related Tasks
Removing the cooling shroud
Installing the cooling shroud
Cooling fans
The system supports an internal cooling fan.
NOTE: When selecting or upgrading your system configuration, verify the system power
consumption with the Dell Energy Smart Solution Advisor at Dell.com/ESSA to ensure optimum
power utilization.
86
To Next Page
Loading...
