Steps
1. Using a screwdriver, push the release tabs on the corners of the blank from inside the system, to
unlock the four-slot hard drive blank from the chassis.
2. From the front of the system, pull the four-slot hard drive blank at the corners until it is free of the
hard drive slot.
Figure 28. Installing and removing the four-slot hard drive blank
1. four-slot hard drive blank 2. release tab (4)
3. screwdriver
Next steps
1. Install the four-slot hard drive blank.
2. Follow the procedure listed in After working inside your system.
Related Tasks
Removing the cooling shroud
Removing a hot swappable hard drive from a hard drive carrier
Removing the hard drive backplane
Installing a four-slot hard drive blank
Installing a four-slot hard drive blank
Prerequisites
1. Ensure that you follow the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
80
To Next Page
Loading...
