Dell poweredge t330 - Removing the Optional Front Bezel; System Feet; Removing the System Feet

Figure 10. Installing and removing the optional front bezel
1. release latch 2. system
3. bezel key 4. slot on the chassis (2)
5. bezel tab (2) 6. bezel
Removing the optional front bezel
1. Unlock the bezel using the bezel keys.
2. Press the release latch at the top of the bezel.
3. Pull the top end of the bezel away from the system.
4. Unhook the bezel tabs from the slots at the bottom of the system board, and pull the bezel away
from the system.
System feet
The system feet provide stability to the system in the tower mode.
Removing the system feet
Prerequisites
NOTE: It is recommended that you remove the system feet only when you are converting the
system from the tower mode to the rack mode, or when you are replacing the system feet with the
wheel assembly.
1. Ensure that you follow the Safety instructions.
2. Keep the Phillips #2 screwdriver ready.
52