Dell poweredge t330 - System Cover; Removing the System Cover

Related Tasks
Installing caster wheels
System cover
Removing the system cover
Prerequisites
1. Ensure that you follow the Safety instructions.
2. Turn off the system and any attached peripherals.
3. Disconnect the system from the electrical outlet and peripherals.
4. If installed, remove the front bezel.
5. Place the system on a flat and stable surface.
Steps
1. Turn the latch release lock to the unlocked position.
2. Press the cover release latch and remove the system cover.
Figure 13. Removing and installing the system cover
1. system 2. system cover
3. cover release latch 4. cover release latch lock
Next steps
Install the system cover.
Related Tasks
Removing the optional front bezel
56