Connecting to the CLI
You can access the CLI using a micro USB cable and terminal emulation software.
1. Connect a micro USB cable from a computer to the CLI port on controller module A .
2. Start a terminal emulator and configure the following display settings and the connection settings:
Table 29. Terminal emulator display settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Font Terminal
Translations None
Columns 80
Table 30. Terminal emulator connection settings
Parameter Value
Connector COM3 (for example)
1,2
Baud rate 115,200
Data bits 8
Parity None
Stop bits 1
Flow control None
1
Your computer configuration determines which COM port is used for the Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
3. If necessary, press Enter to display login prompt.
a. Type the user name of a user with the manage role at the login prompt and press Enter.
b. Type the password for the user at the Password prompt and press Enter.
Topics:
• Micro-USB device connection
Micro-USB device connection
The following sections describe the connection to the micro-USB port:
Emulated serial port
When a computer is connected to a controller module using a micro-USB cable, the controller presents an emulated serial port
to the computer. The name of the emulated serial port is displayed using a customer vendor ID and product ID. Serial port
configuration is unnecessary.
NOTE:
Certain operating systems require a device driver or special mode of operation to enable proper functioning of the
USB CLI port. See also Device driver/special operation mode.
A
134 Connecting to the CLI
To Next Page
Loading...
