Table 26. ME5 Series 2U controller enclosure models (continued)
Model Description Form factor Drives
ME5024 Fibre Channel (32 Gb/s) SFP 2U24 Up to 24 2.5" (SFF) drives
ME5024 iSCSI (25 GbE) SFP 2U24 Up to 24 2.5" (SFF) drives
ME5024 iSCSI 10Gbase-T (10 Gb/s or 1 Gb/s)
1
2U24 Up to 24 2.5" (SFF) drives
ME5024 Mini-SAS HD (12 Gb/s)
2
2U24 Up to 24 2.5" (SFF) drives
1
This model supports 10 Gb/s or 1 Gb/s speeds (used for iSCSI host connections).
2
This model uses SFF-8644 connectors and qualified cable options for host connections.
Table 27. ME5 Series high-density 5U controller enclosure models
Model Description Form factor Drives
ME5084 Fibre Channel (32 Gb/s) SFP 5U84 Up to 84 2.5" (SFF) or 3.5" (LFF)
drives
ME5084 iSCSI (25 GbE) SFP
1
5U84 Up to 84 2.5" (SFF) or 3.5" (LFF)
drives
ME5084 iSCSI 10Gbase-T (10 Gb/s or 1 Gb/s)
1
5U84 Up to 84 2.5" (SFF) or 3.5" (LFF)
drives
ME5084 Mini-SAS HD (12 Gb/s)
2
5U84 Up to 84 2.5" (SFF) or 3.5" (LFF)
drives
1
This model supports 10 Gb/s or 1 Gb/s speeds (used for iSCSI host connection).
2
This model uses SFF-8644 connectors and qualified cable options for host connection.
Attach or remove the front bezel of a 2U enclosure
The following figure shows a partial view of a 2U12 enclosure:
Figure 40. Attaching or removing the 2U enclosure front bezel
To attach the front bezel to the 2U enclosure:
1. Locate the bezel, and while grasping it with your hands, face the front panel of the 2U12 or 2U24 enclosure.
2. Hook the right end of the bezel onto the right ear cover of the storage system.
3. Insert the left end of the bezel into the securing slot until the release latch snaps in place.
4. Secure the bezel with the keylock.
To remove the bezel from the 2U enclosure, reverse the order of the preceding steps.
NOTE: See Enclosure variants for details about various enclosure options.
Module removal and replacement 47
To Next Page
Loading...
