Table 28. Event descriptions and recommended actions (continued)
Number Severity Description/Recommended actions
● No action is required.
221 Info. Snapshot reset has completed.
Recommended actions:
● No action is required.
224 Info. Roll back of data in the indicated volume to data in the indicated snapshot has completed.
Recommended actions:
● No action is required.
232 Warning The maximum number of enclosures allowed for the current configuration has been exceeded.
The platform does not support the number of enclosures that are configured. The enclosure
indicated by this event has been removed from the configuration.
Recommended actions:
● Reconfigure the system.
233 Warning The indicated disk type is invalid and is not allowed in the current configuration.
All disks of the disallowed type have been removed from the configuration.
Recommended actions:
● Replace the disallowed disks with ones that are supported.
235 Error An enclosure management processor (EMP) detected a serious error.
Recommended actions:
● Replace the indicated controller module or expansion module.
Info. An enclosure management processor (EMP) reported an event.
Recommended actions:
● No action is required.
236 Error A special shutdown operation has started. These special shutdown types indicate an
incompatible feature.
Recommended actions:
● Replace the indicated controller module with one that supports the indicated feature.
Info. A special shutdown operation has started. These special shutdown types are used as part of the
firmware-update process.
Recommended actions:
● No action is required.
237 Error A firmware update attempt was aborted because of either general system health issues, or
unwritable cache data that would be lost during a firmware update.
Recommended actions:
● Resolve before retrying a firmware update. For health issues, issue the CLI show system
command to determine the specific health issues. For unwritten cache data, use the CLI
show unwritable-cache command
Info. A firmware update has started and is in progress. This event provides details of the steps in a
firmware-update operation that may be of interest if you have problems updating firmware.
Recommended actions:
● No action is required.
238 Warning An attempt to install a licensed feature failed due to an invalid license.
Recommended actions:
94 Events and event messages
To Next Page
Loading...
