Disassembly and reassembly
Topics:
• Recommended tools
•
Subscriber Identity Module(SIM) board
• Base cover
• Battery
• Solid State Drive
• Hard drive
• Coin-cell battery
• WLAN card
• WWAN card
• Memory modules
• Keyboard lattice and Keyboard
• Heat sink
• Power connector port
• Chasis Frame
• System board
• SmartCard module
• LED board
• Speaker
• Display hinge cover
• Display assembly
• Display bezel
• Display hinges
• Display panel
• Display (eDP) cable
• Camera
• Palm rest
Recommended tools
The procedures in this document may require the following tools:
● Phillips #0 screwdriver
● Phillips #1 screwdriver
● Plastic scribe-Recommended for field technician
Subscriber Identity Module(SIM) board
Installing the Subscriber Identification Module card
1. Insert Subscriber Identification Module (SIM) card removal tool or a paperclip into the pinhole [1].
2. Pull the SIM card tray to remove it [2].
3. Place the SIM on the SIM card tray.
2
10 Disassembly and reassembly
To Next Page
