Installing the M.2 Solid State Drive - SSD
1. Place the SSD clip on the .
2. Tighten the M2x3 screw that secures SSD clip to the .
3. Insert the SSD into the socket on the .
4. ighten the M2x3 screw to secure the SSD to the .
5. Install the:
a. battery
b. base cover
6. Follow the procedure in After working inside your computer.
Hard drive
Removing hard drive assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the hard drive assembly:
a. Disconnect the hard drive cable from the connector on the system board [1].
b. Remove the screws that secure the hard drive assembly to the computer [2].
Disassembly and reassembly
15
To Next Page
Loading...
