Installing the power connector port
1. Insert the power connector port into the slot on the .
2. Place the metal bracket on the power connector port.
3. Tighten the M2x3 screw to secure the metal bracket to the power connector port on the .
4. Connect the power connector port cable to the connector on the system board.
5. Install the:
a. battery
b. base cover
6. Follow the procedure in After working inside your computer.
Chasis Frame
Removing the chassis frame
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. SIM card module
b. base cover
c. battery
d. WLAN card
e. SSD card
3. To release the chassis frame:
Disassembly and reassembly
27
To Next Page
Loading...
