e. chassis frame
3. To remove the LED board:
a. Lift the latch and disconnect the LED board cable from the connector on the LED board [1].
b. Remove the M2x3 screw that secures the LED board to the [2].
c. Lift the LED board away from the [3].
Installing the LED board
1. Place the LED board on the .
2. Tighten the M2x3 screw to secure the LED board to the .
3. Connect the LED board cable to the connector on the LED board.
4. Install the:
a. chassis frame
b. SSD card
c. WLAN card
d. battery
e. base cover
5. Follow the procedure in After working inside your computer.
Speaker
Removing the speaker
1. Follow the procedure in Before working inside your computer.
2. Remove the:
Disassembly and reassembly
35
To Next Page
Loading...
