Installing the coin cell battery
1. Place the coin cell battery on the system board.
2. Connect the coin cell battery cable to the connector on the system board.
NOTE: Route the coin cell battery cable carefully to avoid damaging the cable.
3. Install the:
a. chassis frame
b. battery
c. base cover
4. Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the WLAN card:
a. Remove the M2x3 screw that secures the WLAN card to the [1].
b. that secures the WLAN cables to the WLAN card [2].
Disassembly and reassembly
17
To Next Page
Loading...
