Installing the battery
NOTE: 68Whr battery can be used with either a M.2 or 7mm SATA drive.
1. Insert the battery into the slot on the .
2. Connect the battery cable to the connector on the system board.
3. Tighten the M2.5x5 screw to secure the battery to the .
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Solid State Drive
Removing the M.2 Solid State Drive - SSD
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the SSD:
a. Remove the two M2x3 screw [1] that secures the SSD to the .
b. the SSD card from the [3].
NOTE: For models shipped with NVMe SSDs, remove the thermal plate placed over the SSD.
14 Disassembly and reassembly
To Next Page
Loading...
