Installing the hinge cover
1. Place the hinge bracket to align with the screw holders on the .
2. Tighten the M2x3 screws to secure the display assembly to the .
3. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. hinge cap
3. To remove hinge screws:
a. Remove the M2x5 screws that secure the display assembly to the system board [1].
b. Release the antenna cables and display cable from the routing channel [2, 3].
38
Disassembly and reassembly
To Next Page
Loading...
