6 Follow the procedure in After working inside your system.
WWAN card
Removing the WWAN card
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the WWAN card:
a Disconnect the WWAN cables from the connectors on the WWAN card [1].
NOTE: The WWAN card is held in place with an adhesive foam spacer. When removing the wireless card from the
system, make sure the adhesive pad stays on the system board/chassis frame during the prying process. If the
adhesive pad is removed from the system along with the wireless card, adhere it back to the system.
b Remove the M2x3 screw (1) that secures the WWAN card to the system board [2].
c Lift the WWAN card to release it from the connector on the system board [3].
NOTE: Ensure NOT to pull the WWAN card more than 35°, to avoid pin damage.
Disassembly and reassembly 21
To Next Page
Loading...
