Installing the coin cell battery
1 Place the coin cell battery on the system board.
2 Connect the coin cell battery cable to the connector on the system board.
NOTE: Route the coin cell battery cable carefully to avoid damaging the cable.
3 Install the:
a chassis frame
b battery
c base cover
4 Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the memory module:
a Press the clips securing the memory module until the memory pops-up [1].
b Pull the memory module from the connector on the system board [2].
Disassembly and reassembly
23
To Next Page
Loading...
