Installing the display assembly
1 Place the display assembly to align with the screw holders on the laptop.
NOTE: Close the LCD before inserting the screws or turning over the laptop.
CAUTION: Route the display cable and the antenna cable through the LCD hinge mount holes as LCD assembly is inserted
into the base, to prevent possible cable damage.
2 Tighten the M2x5 screws to secure the display assembly to the laptop.
3 Turn over the laptop.
4 Connect the antenna cables and display cable to the connectors.
5 Place the display cable bracket over the connector and tighten the M2x5 screws to secure the display cable to the laptop.
6 Install the:
a hinge cap
b WLAN card
c battery
d base cover
7 Follow the procedure in After working inside your computer.
Display bezel
Removing display bezel
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c WLAN card
d WWAN card
e display assembly
3 To remove the display bezel:
a Pry the display bezel at the base of the display [1].
NOTE
: When removing or reinstalling the display bezel from the display assembly, technicians should note that the
display bezel is secured to the LCD panel with a strong adhesive and care must be taken to avoid damage to LCD.
b Lift the display bezel to release it [2].
c Pry the edges on the side of the display to release the display bezel [3, 4,5].
CAUTION
: The adhesive used on the LCD bezel to seal it with the LCD itself, makes it hard to remove the bezel as the
adhesive is very strong and tends to stay stuck to the LCD portion and can peel the layers up or crack the glass when
trying to pry the two items apart.
46 Disassembly and reassembly
To Next Page
Loading...
