Installing the keyboard
1 Hold the keyboard and route the keyboard cable and the keyboard backlight cables through the palmrest in the system.
2 Align the keyboard with the screw holders on the system.
3 Replace the M2x2.5 screws (6) to secure the keyboard to the system.
4 Turn the system over and connect the keyboard cable and the keyboard backlight cable to the connector in the system.
NOTE: When reinstalling the chassis frame ensure the keyboard cables are NOT under the lattice , but run through the
opening in the frame before connecting them to system board.
5 Install the:
a keyboard lattice
b battery
c base cover
6 Follow the procedure in After working inside your computer.
Installing the keyboard trim
1 Align the keyboard trim with the tabs on the computer and press the keyboard until the keyboard clicks into place.
2 Follow the procedure in After working inside your system.
Heat sink
Removing the heat sink
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the heat sink - :
a Disconnect the heat sink assembly cable and remove the screws (2) that secure on the system board[1, 2]. .
NOTE
: Remove the screws that secure the heat sink .
Disassembly and reassembly 27
To Next Page
Loading...
