Installing the heat sink
1 Place the heat sink assembly on the system board and align the heat sink with the screw holders.
2 Tighten the M2x3 screws 8 to secure the heat sink assembly to the system board.
3 Connect the heat sink assembly to the connector on the system board.
4 Install the:
a battery
b base cover
5 Follow the procedure in After working inside your computer.
Power connector port
Removing the power connector port
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the power connector port:
a Disconnect the power connector port cable from the connector on the system board [1].
NOTE
: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage.
b Remove the M2x3 screw to release the metal bracket that secures the power connector port [2].
c Remove the metal bracket that secures the power connector port [3].
d Lift the power connector port away from the laptop [4].
Disassembly and reassembly
29
To Next Page
Loading...
