Dust filter
The dust filter for the Precision Tower 3640 helps protect the system from fine dust particles. After installation of the dust filter, the BIOS
can be enabled to generate a preboot reminder to clean or replace the dust filter based on the time interval set.
About this task
Follow these steps to install the dust filter:
Steps
1. Align the plastic tabs of the dust filter to the slots on the system chassis and gently press to ensure that the dust filter fits firmly onto
the system.
2. To remove the dust filter:
a. With the help of a plastic scribe, gently pry the edge from the bottom to loosen the dust filter [1].
b. Remove the dust filter from the system chassis [2].
B
Dust filter 111
To Next Page
Loading...
