4. Close the PSU hinge.
5. Install the Front bezel
6. Install the cover.
7. Follow the procedure in After Working Inside Your Computer.
WLAN module and SMA antenna
Removing WLAN module and SMA antenna
Steps
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. Cover
b. PSU hinge
3. Remove the single M2x3.5 screw that secures the WLAN card to the system board, un-route the antenna cables from the rubber
guides on the system board [1].
4. Slide and remove the external antenna connector from the PCIe slot on the chassis [2].
Disassembly and reassembly
49
To Next Page
Loading...
