Installing heatsink assembly - 65 W or 80 W CPU
About this task
These steps applies to system configurations shipped with 65 W or 80 W CPU.
Steps
1. Align the heat sink assembly with the screw holders on the system board and place it on the processor [1].
2. Tighten the 4 captive screws to secure the heat sink assembly to the system board [2].
NOTE: Tighten the screws in a sequential order (1,2,3,4) as mentioned on the system board.
3. Connect the heat sink assembly cable to the connector on the system board [3].
Disassembly and reassembly
71
To Next Page
Loading...
