4. Close the PSU hinge.
5. Install the cover.
6. Follow the procedure in After working inside your computer.
System board
Removing the system board
Steps
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. Cover
b. PSU hinge
c. Memory module
d. Graphics card
e. SSD
f. WLAN module and SMA antenna
g. Heatsink assembly
h. VR heat sink (for models shipped with 95W heat sink assembly)
i. Processor
3. Remove the following cables:
• System fan cable, intrusion cable, and IO panel cable [1]
• CPU power cable [2]
• System board power connector cable [3]
4. Remove the following cables:
• SD card cable [1]
• Type-C cable [2]
• IO USB cable [3]
Disassembly and reassembly
89
To Next Page
Loading...
