5. Install the:
a. IO panel
b. Optical drive
c. Front bezel
d. Cover
6. Close the PSU hinge.
7. Follow the procedure in After Working Inside Your Computer.
Heatsink assembly
Removing heatsink assembly - 65 W or 80 W CPU
About this task
These steps applies to system configurations shipped with 65 W or 80 W CPU.
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the Cover.
3. Open the PSU hinge.
4. To remove the heat sink assembly:
a. Disconnect the heat sink assembly cable from the connector on the system board [1].
b. Loosen the 4 captive screws that secure the heat sink assembly [2] and lift it from the system [3].
68
Disassembly and reassembly
To Next Page
Loading...
