4. Install the:
a. Heatsink assembly
b. PSU hinge
c. Cover
5. Follow the procedure in After Working Inside Your Computer.
Intrusion switch
Removing intrusion switch
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the cover.
3. Open the PSU hinge.
4. To remove the intrusion switch:
a. Disconnect the intrusion switch cable from the connector on the system board [1].
b. Unroute the intrusion switch cable from the routing clips on the chassis [2].
c. Slide the intrusion switch and lift it to remove from the computer [3].
Disassembly and reassembly
87
To Next Page
Loading...
