Optional IO card
Removing optional IO card
About this task
NOTE: You may see one of these cards-HDMI/DisplayPort/VGA/Type-C based on the additional component you may
have ordered with the system.
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the cover.
3. Open the PSU hinge.
4. To remove the optional IO card:
a. Disconnect the IO card cable from the connector on the system board [1].
b. Remove the two M3X3 screws that secure the IO card to the system [2].
c. Remove the IO card from the system [3].
Installing the optional IO card
Steps
1. To remove the metal bracket as shown below, insert a flathead screwdriver in the hole of the bracket [1], push the bracket to release
the bracket [2], and then lift the bracket out from the system.
84
Disassembly and reassembly
To Next Page
Loading...
