5. Close the PSU hinge.
6. To remove the power supply unit (PSU):
a. Disconnect the hard-disk power cable [1].
NOTE: There could be up to four hard-disk power cables depending on the quantity of hard-disk drive installed.
b. Remove the two #6-32x1/4'' screws that secure the power-supply bracket to the chassis [2] and lift the power-supply bracket
from the system [3].
c. Remove the four #6-32x1/4'' screws that secure the power-supply unit to the chassis [4].
d. Lift the PSU off the chassis [5].
Disassembly and reassembly
43
To Next Page
Loading...
